hi,
started again to test mooz 1 and having oozing and bulb issues. Usually retraction is the way to handle
these but on mooz it was getting worse. After some hours i figured mooz does not support retraction.
If you press the E down filament button on the touch pad it extracts about 2 mm of filament, like it should. But also if you press E up, it also extracts 2 mm of filament.
also this g-code behaves the same, only extraction of filament. No retraction:
M117 Preparing…
M107 ; Turn layer fan off
G21 ; Metric
M92 E106.40502
G1 E2 F100 ; extract
G4 P10000
G1 E-1 F100 ; retract
G4 P10000
G28 ; home all axes
i have firmware 1.4.5. Update seemed to be ok.
Touch pad update was left hanging on
Baud: 9600
SD Card Update…