The robot has been running a simple script of moving between pgm’d points. I added a second LAN2 and changed IP address, which it can connect on either LAN. Now, the script or even a simple Blockly will not run. No script errors as it runs to completion (although in about 2 sec), ring LED blinks green, but the robot doesn’t move. I can job, runto the points w/o any issue. Just can’t get script to run! I’ve changed the LAN2 back to 192.168.2.6, and even disconnected LAN2, power off/on robot, relaunch StudioPro, nothing! Any ideas?
MG400 Doesn't Run Script or Blockly
apinkos32
#2
I found the issue with syntax. RelMovL({0,10,0,0}) . Where can I find the lua script syntax manual so I know all of these fine details?