My Mooz 2 plus having issue with staring a print. First when a file was selected, the nozzle will not heat up. I will have to press pause then resume to have the nozzle start to heat up. Once it reach temp, Mooz will execute homing and again after the homing, it will beep then pause again. I will have to press pause and resume to get it going. I need to pause, resume a couple of time to start a new print. This is unacceptable, any suggestion and what I did wrong?
A lot of homing and pause
Skyice
#2
Is there a way too change the startup script? and what to do with the system idle after file was selected? Right now I have to press “Pause” then “Resume” before the nozzle heater will start to heat up.