3D Printer Extruder Temperature

#1

When the Dobot Magician is connected to Repetier-Host the extruder temperature (at ambient) shows 357C. How do I calibrate to the actual temperature?

Dobot Magician stop while printing and printing result not Ok
#2

The thermistor is shorted somewhere. Loosen the screw here and make sure the two pins of the thermistor isn’t shorted out with each other:

Pasted image740x594 416 KB

#3

Is there any way to install a custom thermistor and update the temperature table in the firmware? If not manually, is that something that the customer service can help with?

#4

I am facing some issue on my 3D printer and I am using Canon printer. It was running properly previously. but now it is showing Canon Printer Paper Jam error. If you have any useful ideas to fix this please help me with the proper solution.

#5

Make sure the port is not occupied and select the corresponding port.